Standard operating parameters：

Runout: 0.5mm

Linear speed: 15m/s

Pressure: 0 bar

Temperature range: -40 to 120°C

Movement amount: 0.5mm

Special design up to 1.5mm

Shaft/Hole Tolerance: ±0.05mm

*Special designs available

Sealing material：

Standard: Special PTFE

Maintenance: Grease and splash oil (the oil level in the cavity between the seal and the bearing must be below the "F" line of the oil return hole on the inside of the seal).

Exclusion: Exclude a large amount of water mist and dry dust contamination in the bearing cavity.

Equipment: Engines, pumps, mixers, gearboxes, blowers and custom equipment.