Standard operating parameters：

Runout: 0.5mm

Line speed: 25m/s

Pressure: 0 bar

Temperature range: -40 to 120°C

Movement amount: 0.5 mm

Special designs up to 1.5 mm

Shaft/Hole Tolerance: ±0.05 mm

Special designs available

Sealing material：

Standard: Special PTFE

Scope of application：

Standard: Viton

Optional: Nitrile rubber, FDA grade silicone rubber, ethylene propylene rubber, Aflas fluoroelastomer

Maintenance: Grease and splash oil (the oil level in the cavity between the seal and the bearing must be below the "F" line of the oil return hole on the inside of the seal).

Exclusion: Exclude water mist and contaminants in the bearing cavity, it is most suitable when the equipment needs to be used upright.

Equipment: Motors, pumps, mixers, gearboxes, blowers and custom equipment