Standard operating parameters：

Runout: 0.25 mm

Linear speed: 35m/s

Pressure: 0 bar

Temperature range: -40 to +200°C

Momentum: 0.25mm

Special design up to 2.5 mm

Shaft/Hole Tolerance: ±0.05 mm

*Special designs available

Sealing material：

Standard: Bronze

Optional: Stainless Steel 302, 304, 316, Carbon Steel

O-ring material：

Standard: Viton

Optional: Nitrile rubber, FDA silicone rubber, ethylene propylene rubber, Aflas® fluoroelastomer

Maintenance: Grease and splash oil (the oil level in the cavity between the seal and the bearing must be below the "F" line of the oil return hole on the inside of the seal).

Exclusion: Exclude a large amount of water mist and dry dust contamination in the bearing cavity.

Equipment: Engines, pumps, mixers, gearboxes, blowers and custom equipment.