Standard operating parameters：

Runout: 0.5 mm

Line speed: 25m/s

Pressure: 0 bar

Temperature range: -40 to 120°C

Movement amount: 0.5mm

Special design up to 1.5mm

Shaft/Hole Tolerance: ±0.05 mm

Special designs available

Sealing material：

Standard: Special PTFE

Scope of application：

Standard: Viton

Nitrile rubber, FDA silicone rubber, ethylene propylene rubber, Aflass® fluoroelastomers

Maintenance: Lube and splash oil (the oil level in the cavity between the seal and bearing must be below the "F" line of the oil return hole on the inside of the seal).

Exclusion: Exclude water mist and contaminants from bearing cavities.