Standard operating parameters：

Runout: 0.5mm

Linear speed: 15m/s

Pressure: 0 bar

Temperature range: -40 to 120°C

Movement amount: 0.5mm

Special design up to 1.5mm

Shaft/Hole Tolerance: ±0.05mm

*Special designs available

ASL type sealing material：

Standard: Special PTFE

Optional: Food Grade, Antimicrobial, FDA 3A

ASL type sealing material：

Standard: Copper

Optional: Stainless Steel 302, 304, 316, Carbon Steel

O-ring material：

Standard: Viton

Optional: Nitrile rubber, FDA silicone rubber, ethylene propylene rubber, Aflas® fluoroelastomer

Maintenance: Grease and splash oil (the oil level in the cavity between the seal and the bearing must be below the "F" line of the oil return hole on the inside of the seal).

Exclusion: Exclude a large amount of water mist and dry dust contamination in the bearing cavity.

Equipment: It is used when the equipment cannot be disassembled and needs to be installed on site according to the equipment conditions. Shafts do not require refurbishment and wear sleeves are not required. Engines, pumps, mixers, gearboxes, blowers and custom equipment.